UV Head refresh

To perform a head refresh follow all of these steps, the supplies for this are found on the bottom left drawer of the machine.

1. If the message "DO HEAD REFRESH" is displayed, press [ENTER], If this message is not displayed, follow these steps:
   1. Press [FUNCTION]
   2. Press [▶] to display "CLEANING > HEAD REFRESH"
   3. Press [ENTER]
2. Press [◀] or [▶] to select "YES"
3. Press [ENTER].
4. When the "SET HEAD > REFRESHER" message is displayed, open the front cover.
5. Check that nothing has been placed on top of the flat table
6. Attach the head refresher to the table on the bottom left corner:

   

   This is where the head refresher should be placed

7. Remove the head refresher cover.
8. Attach the head cleaning sheet to the head refresher using the following steps:
   1. Open the sheet retaining cover
   2. Position the head cleaning sheet atop the row of small sponges, constituting the wiping component of the head refresher.
   3. Close the sheet retaining cover to secure the head cleaning sheet in place.
9. Press [ENTER]
10. When the "APPLY CL-LIQUID > START REFRESH" screen is displayed, apply 2 or 3 drops of cleaning liquid to each of the little sponges on the head cleaning sheet
11. Close the front cover
12. Press [ENTER], this will start the head refreshing and might take a couple minutes
13. When the "REMOVE HEAD REFRESHER" screen is displayed, open the front cover
14. Put on some gloves
15. Open the sheet retaining cover
16. Remove the head cleaning sheet
17. Throw the head cleaning sheet in the chemical waste container
18. Check that there are traces of ink being wiped off onto the head cleaning sheet.
19. Close the sheet retaining cover
20. Place the head refresher cover back on the head refresher
22. Remove the head refresher
23. Close the front cover.
24. Press [ENTER].
25. When "SETUP MEDIA" or "CLEANING HEAD REFRESH" screen is displayed, the head refreshing is finished