Epilog Carriage Camera Calibration

Carriage Camera Calibration The following procedure must be performed first for all Fusion Pro machines. If you have already done this, you may skip the Carriage Camera Calibration and proceed to the Carriage Camera Calibration

1. Turn on the engraver, and let it complete the startup process
2. On the display, press the gear icon to enter the Settings Menu
3. Press and hold the word “Settings” on the touchpad to gain access to the Advanced Settings menu:
4. Press Calibrate Cameras:
5. Place an 8” x 5” (200mm x 125mm) piece of anodized aluminum in the top left corner of the table.
6. Close the top door of the engraver.
7. Press OK to begin the carriage camera calibration and the engraver will move the table to the appropriate focal height for calibration.
8. The engraver will mark the anodized aluminum with a pattern that the carriage camera analyzes for calibration. Once the job is complete, a success message should appear.
9. Follow the on-screen prompts to continue to the overhead camera calibration.